Gimbal Camera Yaw Roll Bracket Arm/Pitch Roll Yaw Motor for DJI Phantom 4/Phantom 4 Pro

DJI Phantom 4 Phantom 4 Pro Gimbal Camera Yaw Roll Bracket Phantom 4 4 Pro Pitch Roll Yaw Motor USED

1: Yaw Motor for DJI Phantom 4 (New Version)=Yaw Motor for DJI Phantom 4 Pro (New Version)

2: Yaw Motor for DJI Phantom 4 (Old Version)

3: Roll Motor for DJI Phantom 4=Roll Motor for DJI Phantom 4 Pro

4: Pitch Motor for DJI Phantom 4

5: Yaw Bracket for DJI Phantom 4

6: Roll Bracket for DJI Phantom 4

7: Yaw Motor for DJI Phantom 4 Pro (New Version) =Yaw Motor for DJI Phantom 4 (New Version)

8: Roll Motor for DJI Phantom 4 Pro=Roll Motor for DJI Phantom 4

9: Pitch Motor for DJI Phantom 4 Pro

10: Yaw Bracket for DJI Phantom 4 Pro

11: Roll Bracket for DJI Phantom 4 Pro

12: Yaw Bracket for DJI Phantom 4 Pro obsidian

13: Roll Bracket for DJI Phantom 4 Pro obsidian

Note:

For P4 Roll Motor Suitable for P4P, for P4A, for P4PRO V2.0, for P4RTK, for P4 new motor

(Note: There are two types of motors for P4, one is new and the other is old. for P4 basically uses new motors, but there are also old motors.

If the customer's machine is an old motor , but already bought our product,

There are two ways to install and use:

1. Install the base of the old motor to our new motor;

2. Remove his shock absorber plate and replace it with a for P4 Pro one. shock absorber)

Tips 1:

Please note that   these Motors are used.   But it works because we tested before sell.

For now,nobody have this new these Motors because dji company forbid to sell.

Tips 2:

Kindly reminder: These parts require professionals and professional tools to replace. Especially the Y motor, it need professinal tool to fix and replace. We recommend that you check with your local professinal repairnan before buy it.

Tips 3:

If the gimbal camera doesn't fixed in the center after install the Y motor, pls following below steps to settle the problem.

Step 1: Measure the deviation angle of the gimbal camera;

Step 2: Measure and mark making on the counterclockwise direction of the metal plate   (the one for motor, above the shock-absorbing plate, next to the flat cable);

Step 3: Drill a screw hole with an electric drill on the metal plate. (If the gimbal camera go to the left deviation of 45 degrees, then pls drill a hole of 45 degrees to the right.)

Step 4: Install the Y motor.