UNRC UN-A6 MAX 5A RC LiPo Battery Charger Assistant Unit
UN-A6 Charger Assistant (maximum to charge 24 x 2S , 16 x 3S or 8 x 6S Li-Po batteries one by one)
UN-A6 charger assistant is a charging extender unit specially designed fro UN-A6, capable of automatically charging multiple lipo batteries alternatively and also have automcatic discharging function! When there is more than one lipo battery needs to be charged, only need to connect the battery to any charging port individually, and it can automatically detect whether this battery needs to be charged. If yes, then, it will fully charge this battery and then turn to next port, then charge again, very convenient to use!
UN-A6 has totally 8 charging ports, each one was divided to 1x6s, 2x3s, 3x2s charging ports. Because of the speical voltage-division charging method, you can charge at most 24 x 2S , 16 x 3S or 8 x 6S Li-Po batteries, and can even support up to 5A current!
Un-A6 adopts votage-division charging method, aimed at charging the single chip of each lipo battery, which is more advanced than the regular series charging plus ballancer, so the charging effect is better!
Feature of UN-A6 charger assistant:
- Use array voltage driving circuit to take place the old relay, no matter to care about the switch life anymore.
- Low resistance MOS resistors is used to maximize the highest power output.
- Support automatically charging at most 24 x 2S , 16 x 3S or 8 x 6S Li-Po batteries alternatvively.
- Built-in professional discharger allows discharge for each cell, thus balance the Li-Po battery.
- Discharge voltage limitation can be set from 1.5V to 4.2V (0.01V stepping).
- LED showing the status of each set
- Safefy stop feature allow the charger to automatically cut off the power in 5 secound in case of error/problem.
- Reserved 2 data inpurt interface, compatible with hardware of both new and old UN-A6!
Specification of UN-A6:
Size: 167mm x 84.6mm x 36mm
Weight: 320g
Maximum Charging Current: 5A
Support Charging method: 24 x 2S , 16 x 3S or 8 x 6S Li-Po batteries
Charging Method: Alternatively charging
Other function: Discharging (discharging voltage can be set, 0.01V stepping)
Requirment: Must work with UN-A6 charger
Note: If customers need to charge with large current, make sure to use the switch supply with proper power
How to use:
please connect the data cable from the UN-A6 PLUS to the in1 port of the unit. inout port connect to the charger's 6S output port. ports 1-8 is for the Li-Po batteries
charging: after power on the UN-A6 PLUS charger, please set the charing mode to 02. Then it will automatically check the batteries and ready for charging.
discharging: after power on the UN-A6 PLUS charger, please set the charing mode to 03. Then it will automatically check the batteries and ready for discharging. the discharge current is automatically adjusted by the charger, cannot set manually.
protection mode: if in any situation that the charger cannot detect a working connection, it will start to count down for 5 secounds and cut off all operation afterward to protect the devices and all the batteries.
Warning: NEVER charge different types of battery at the same time! e.g. DO NOT charge 3S and 6S Li-Po together.
